Delta MH300 Series - Page 286

Chapter 11 Summary of Parameter Settings
MH300
11-27
Pr. Parameter Name Setting Range
Default
05-16
Number of poles for
induction motor 2
2–20 4
05-17
No-load current for induction
motor 2 (A)
0.00–Pr.05-13 default
Depending
on the
model
power
05-18
Stator resistance (Rs) for
induction motor 2
0.000–65.535 Ω
Depending
on the
model
power
05-19
Rotor resistance (Rr) for
induction motor 2
0.000–65.535 Ω
0.000
05-20
Magnetizing inductance
(Lm) for induction motor 2
0.0–6553.5 mH
0.0
05-21
Stator inductance (Lx) for
induction motor 2
0.0–6553.5 mH
0.0
05-22
Multi-motors (induction)
selection
1: Motor 1
2: Motor 2
3: Motor 3 (V/F or SVC control mode only)
4: Motor 4 (V/F or SVC control mode only)
1

05-23
Frequency for Y-connection
/ Δ-connection switch for an
induction motor
0.00–599.00 Hz
60.00
05-24
Y-connection / Δ-connection
switch for an induction motor
0: Disable
1: Enable
0

05-25
Delay time for Y-connection
/ Δ-connection switch for an
induction motor
0.000–60.000 sec.
0.200
05-26
Accumulated Watt-second
for a motor in low word
(W-sec.)
Read only
0.0
05-27
Accumulated Watt-second
for a motor in high word
(W-sec.)
Read only 0.0
05-28
Accumulated Watt-hour for
a motor (W-hour)
Read only 0.0
05-29
Accumulated Watt-hour for
a motor in low word
(kW-hour)
Read only 0.0
05-30
Accumulated Watt-hour for
a motor in high word
(kW-hour)
Read only 0.0
05-31
Accumulated motor
operation time (minutes)
0–1439 min. 0