Delta MH300 Series - Page 315

Chapter 11 Summary of Parameter Settings
MH300
11-56
Pr. Parameter Name Setting Range Default
12-19
Linear speed input
command source
0: Disabled
1: Analog input
2: RS-485 communication input
3: PG card pulse input
4: DFM-DCM pulse input
5: Pulse input through MI6 / MI7 terminal
0
12-20 Maximum linear speed 0.0–6500.0 m/min. 1000.0
12-21 Minimum linear speed 0.0–6500.0 m/min. 0.0
12-22 Pulses per meter 0.0–6000.0 pulses/m 0.0

12-23 Current linear speed 0.0–6500.0 m/min. 0.0

12-24
Linear speed low pass
filter time
0.00–100.00 sec. 0.10

12-25
Linear speed command
acceleration time
0.00–655.35 sec. 0.00

12-26
Linear speed command
deceleration time
0.00–655.35 sec. 0.00
12-27 Reel diameter source
0: Calculated via line speed
1: Calculated via analog input selection
2: Calculated via thickness integral, the encoder installed
at reel side inputs by PG card
3: Calculated via thickness integral, the encoder installed
at motor side inputs by PG card
4: Calculated via thickness integral, the encoder installed
at reel side inputs by MI6 / MI7 terminals
5: Calculated via thickness integral, the encoder installed
at motor side inputs by MI6 / MI7 terminals
0
12-28 Maximum reel diameter 1.0–6000.0 mm 6000.0
12-29 Empty reel diameter 1.0–6000.0 mm 1.0
12-30 Initial reel diameter source
0: RS-485 communication input (Pr.12-31)
1: Analog input (Pr.03-00–03-01 = d16)
0

12-31 Initial reel diameter 1.0–6000.0 mm 1.0
12-32 Initial reel diameter 1 1.0–6000.0 mm 1.0
12-33 Initial reel diameter 2 1.0–6000.0 mm 1.0
12-34 Pulses per revolution 1–60000 ppr 1
12-35 Revolutions per layer 1–10000 1
12-36 Material thickness 0.001–65.000 mm 0.001

12-37 Reel diameter filter time 0.00–100.00 sec. 1.00
12-38
Automatic reel diameter
compensation
0: Disabled
1: Enabled
0