Delta MH300 Series - Page 369

Chapter 12 Description of Parameter Settings
MH300
12.1-02-2
Pr.02-00 External terminal control circuits
Setting value: 5
Two-wire
Quick Start
Setting value: 6
Three-wire
Quick Start
02-01
Multi-function Input Command 1 (MI1)
02-02
Multi-function Input Command 2 (MI2)
02-07
Multi-function Input Command 7 (MI7)
Default: 0
02-03
Multi-function Input Command 3 (MI3)
Default: 1
02-04
Multi-function Input Command 4 (MI4)
Default: 2
02-05
Multi-function Input Command 5 (MI5)
Default: 3
02-06
Multi-function Input Command 6 (MI6)
Default: 4
02-26
Input Terminal of extension card (MI10)
Default: 0
02-27
Input Terminal of extension card (MI11)
Default: 0
02-28
Input Terminal of extension card (MI12)
Default: 0
Settings 0: No function
1: Multi-step speed command 1
2: Multi-step speed command 2
3: Multi-step speed command 3
4: Multi-step speed command 4
5: Reset
6: JOG operation [by external control or KPC-CC01 (optional)]
7: Acceleration / deceleration speed inhibit
8: The first and second acceleration / deceleration time selection
9: The third and fourth acceleration / deceleration time selection
10: External Fault (EF) input (Pr.07-20)
11: Base Block (B.B.) input from external