Chapter 12 Description of Parameter Settings
MH300
Settings
Functions Descriptions
5 Reset Use this terminal to reset the drive after clearing a drive fault.
6 JOG operation
This function is valid when the source of the
is the external terminals.
The JOG operation executes when the drive stops completely.
While running, you can still change the operation direction, and
the STOP key on the keypad* and the STOP command from
communications are valid. Once the external terminal receives
the OFF command, the motor stops in the JOG deceleration
time. Refer to Pr.01-20–Pr.01-22 for details.
* : This function is valid when Pr.00-32 is set to 1.
7
Acceleration /
deceleration speed
inhibit
When you enable this function, the drive stops acceleration or
deceleration immediately. After you disable this function, the AC
motor drive starts to accelerate or decelerate from the inhibit
point.
8
The first and second
acceleration /
deceleration time
selection
You can select the acceleration and deceleration time of the
drive with this function, or from the digital status of the terminals;
there are four acceleration and deceleration selections.
9
The third and fourth
acceleration /
deceleration time
selection
To Next Page
Loading...
