Delta MH300 Series - Page 495

Chapter 12 Description of Parameter Settings
MH300
12
.1-09-8

09-88
Communication Card Password (low word) (for EtherNet)

09-89
Communication Card Password (high word) (for EtherNet)
Default: 0
Settings 0–99

09-90
Reset Communication Card (for EtherNet)
Default: 0
Settings 0: Disable
1: Reset, return to default

09-91
Additional Settings for the Communication Card
(for EtherNet)
Default: 0
Settings bit 0: Enable IP filter
bit 1: Enable Internet parameters (1 bit)
When the IP address is set, this bit is enabled. After updating the
parameters for the communication card, this bit changes to be disabled.
bit 2: Enable login password (1 bit)
When you enter the login password, this bit is enabled. After updating
the communication card parameters, this bit changes to be disabled.

09-92
Communication Card Status (for EtherNet)
Default: 0
Settings bit 0: Enable password
When the communication card is set with a password, this bit is enabled.
When the password is cleared, this bit is disabled.