Chapter 13 Warning Codes|MH300
ID No.
Display Warning Name Description
18
Speed deviation
warning (dAvE)
Over speed deviation warning
Action and Reset
Action level Pr.10-13
Action time Pr.10-14
Warning setting parameter
Pr.10-15=0
0: Warn and keep operation
Reset method “Warning” automatically clears when the drive stops
Reset condition After the drive stops
Record N/A
Cause Corrective Actions
Improper parameter setting for
the slip error
Reset proper value for Pr.10-13 and Pr.10-14.
Improper setting for ASR
parameter and acceleration/
deceleration
Reset ASR parameters.
Set proper accel./ decel. time.
Accel./ Decel. time is too short Reset proper accel./ decel. time.
Motor locked Remove the causes of motor locked.
Mechanical brake is not
released
Check the active timing of the system.
Incorrect parameter setting of
torque limit
(Pr.06-12, Pr.11-17–20)
Adjust to proper setting value.
Malfunction caused by
interference
Verify wiring of the control
circuit, and wiring/grounding of the main circuit
to prevent interference.
To Next Page
Loading...
