Dieci SAMSON AGRI MAX - Forks Use; Forks Adjustment

Equipment | 10
DOCMA0000006‐UK ﴾ENG﴿ ‐ Samson FPT 3A 197
Check the integrity of the welds
Check that all the welds on the forks “3” (fig. 1505204) are in
goodconditionsandhavenocracksoranomalies.
150520-4
10.6.4 Forks use
CAUTION
Before starting to use the equipment, inspect and test it as described in the section "Equipment pre-use
check".
WARNING
It is absolutely forbidden to use the forks or any type of equipment, without securing it to the tool holder
plate with the appropriate safety pins.
DANGER
Before each use, check the wear status of the forks, they could be worn out and not hold
the load to be handled creating a dangerous situation.
Before starting to use the equipment, refer to the chapters:
a) "Safetyregulations"
b) "Safeworkingprocedures"
c) "Forkscheck"
Tousetheforksitissufficienttomovethecontrolsfortheplate
tilting.
Bymovingthejoysticktotheleft,thetipsoftheforkswillrise;by
movingthejoysticktotheright,thetipsoftheforkswilldrop.
150521-1
10.6.5 Forks adjustment
Toadjustthepositionoftheforksitisnecessaryto: