Dieci SAMSON AGRI MAX - Passengers Transportation; Electrical System Protection; Signals to Multiple Vehicles

Safety regulations | 5
DOCMA0000006‐UK ﴾ENG﴿ ‐ Samson FPT 3A 39
5.7.4 Passengers transportation
Onlytheoperatormustbeonboardthevehicle,passengersarenotadmitted.
Passengersmayobstructtheoperator'sview,causinganunsafeoperationofthevehicle.
WARNING
Carrying people on or lifting people up with the vehicle is strictly prohibited unless the vehicle is
equipped with an elevation work platform and has a special certificate of conformity regarding the
transport of people.
WARNING
It is strictly forbidden to transport persons inside the basket while the vehicle is moving even in the
presence of elevation work platform and certificate of conformity. It is compulsory to use the basket only
with the parking brake engaged and the outriggers lowered (if present).
5.7.5 Electrical system protection
Aburntfusemustbereplacedwithanotherfuseofthesametype,amperageandclass.
Othertypesofinterventionsarenotallowed,eveniftemporary.
Do not connect or remove terminals, fuses, or connectors when the vehicle is switched on or electrically
powered.
Anyinterventionontheelectricplantmusttakeplacewiththevehiclenotpoweredelectrically.Restorethe
powersupplyonlyaftertheinterventionhasbeenconcluded.Remountthelidsandprotections.
– Usethebatteryisolatortocutoffpowertothevehicle.
– Cutoffpowerbymeansofthebatterycutoffevenbeforereplacingthevehiclebattery.
– Intheeventthataconnectorisdamagedorisnolongerinsertedinitshousing,replaceitimmediatelyin
ordertoavoidshortcircuitsorsparks.
Damaged,pinchedorburntcablesmustbereplacedimmediatelyevenifdamageisonlytothesheathingor
outerinsulation.
– Nevercarryoutorinterruptanyconnectionontheloadcircuit,includingconnectionsonthebattery,with
theenginerunning.
– Neverground(earth)shortcircuitanychargingcomponent.
– Donotuseanauxiliarybatterywithnominalvoltageexceeding12volt.
– Makesurethe polarity iscorrectwhenputting inthebatteryor when usinganauxiliary battery when
startingthevehiclewithcables.Followtheuseandmaintenanceinstructionsofthemanualwhenstarting
upthevehiclewithcables.
Alwaysdisconnectthenegativecablefromthebatterybeforeperformingarcweldingonthevehicleoron
anyconnectedattachment.
– Positiontheweldingmachine’sgroundterminalascloseaspossibletotheareatobewelded.
– Ifweldingistobecarriedoutnearanelectricalmodule,thismodulemustberemovedfromthevehicle.
– Onlyqualifiedandauthorizedpersonnelshouldcarryoutthisoperation.
– Do not allow welding machine cables go above, near or cross over any electrical cable or electronic
componentwhileweldingisinprogress.
5.7.6 Signals to multiple vehicles
Whenworkingrequiring more vehicles, givesignalsnormallyknown to allemployedpersonnel.Designate
onepersontosignalandcoordinatetheworkzone.
Before operating make sure that: