Dieci SAMSON AGRI MAX - Start up with Auxiliary Batteries

12 | Maintenance
226 DOCMA0000006‐UK ﴾ENG﴿ ‐ Samson FPT 3A
12.4.6 Start up with auxiliary batteries
CAUTION
Start-up with auxiliary batteries is an operation that requires two properly trained and qualified operators.
WARNING
Start-up with auxiliary batteries is an operation that requires two properly trained and
qualified operators.
An error in executing the operations can cause serious damage to the vehicle, to property and people.
– Whenstartingtheengineusinganothervehicle,connecttheaccumulatorsinparallel.Whenconnecting
thecables,avoidcontactbetweenthepositivecable"+"andthenegativecable"".
– Wearthenecessarypersonalprotectiveequipmentbeforestartingtheoperation.
– Takecaretoavoidcontactbetweenthevehicletobestartedandthevehiclethatmustsupplypowerto
preventsparksandexplosionsofhydrogenproduced bytheaccumulators.Theaccumulatorexplosion
causesseriousdamageandinjury.
– Makesurenottoexchangetheignitionwiresandfirstconnecttheearthwire()andthenthepositive
wire(+).
– Be very careful when removing the ignition cables; to ensure that the cables disconnected from the
accumulatordonottouchotherpartsofthevehicletoavoidexplosionscausedbyhydrogen.
– Cablesandclamps must beproportionaltothecurrent load tobetransferred.The accumulator tobe
used for the startup must have a capacity greater than or at least equal to that of the standard
accumulatorinstalled.
– Check the cables and clamps for corrosion or damage. Make sure the clamps are tightly gripping the
terminals.
– Beverycarefulduringthedifferentoperations:directorindirectcontactwithlivepartscanresultininjury
andsometimesevenindeath.
– When starting the engine, the operator must be in the driver's seat so as to keep the vehicle under
control.
– Alltheseoperationsmustbecarriedoutbyskilledandtrainedpersonnel.
12.4.6.1 Cable connection and engine start-up
1. Makesuretheignitionkeyisinposition"O".
2. Connect the positive terminals"+" of the two batteries to
eachother.
3. Connect the cable from the negative terminal "" of the
chargedbatterytotheearthblockofthevehicletostartup.
4. Ifachargedbatteryinstalledonaproperlyrunningvehicleis
used,starttheengineofthelatterandrunitathighrpm.
5. Starttheengineofthefailedvehicle.
NOTICE!In case the battery is not easily accessible, it is
possible to connect the cables through the battery cut‐
off switch of the vehicle.
1. Thenconnectthepositiveterminal"+"oftheauxiliarybattery
toaconnectorofthebatterycutoffswitch.
150539-1