10 | Equipment
210 DOCMA0000006‐UK ﴾ENG﴿ ‐ Samson FPT 3A
10.8.4 Bucket use
WARNING
Before starting to use the equipment, inspect and test it as described in the section
"Equipment pre-use check".
It is absolutely forbidden to use the forks or any type of equipment, without securing it to the tool holder
plate with the appropriate safety pins.
DANGER
Before each use, check the wear status of the equipment, they could be worn out and not hold the load to
be handled creating a dangerous situation.
Before starting to use the equipment, refer to the chapters:
a) "Safetyregulations"
b) "Safeworkingprocedures"
c) "Equipmentpreusecheck"
CAUTION
Set the appropriate working mode of the machine during the bucket use. If this is not done properly, the
anti-tipping device could start up and the movements will consequently stop during the bucket
excavation or the loading.
To use the buckets it is sufficient to move the plates swiveling
controls.
Movingthejoysticktotheleft,thetipofthebucketwillmoveup;
movingthejoysticktotheright,thetipofthebucketwillmove
down.
150630-1
WARNING
Given the large size of the buckets, for some movements it will be necessary to remove the boom to
prevent contact of the bucket with other parts of the machine. It is advisable to operate with the
minimum possible extension of the boom.