10 | Equipment
176 DOCMA0000006‐UK ﴾ENG﴿ ‐ Samson FPT 3A
10 Equipment
10.1 General warnings on equipment use
DANGER
It is strictly forbidden to modify the structure of the equipment or adjust the safety devices of the various
tool components.
– Only equipment CE certified by the relative manufacturer can be used on DIECI vehicles, as well as
equipmentapprovedorfallingwithinthetechnicallimitssetoutbyDIECI S.r.l.Theguaranteeisvoidif
notapprovedequipmentisused.
– Theinterchangeableequipmentmanufacturermustguaranteethatthecombinationofsuchequipment
and the basic vehicle on which the equipment is intended for, meets all the basic health and safety
requirements,providinganadequateevaluationprocedureofcompliance.
– DIECI S.r.l.liabilityshallnotbeinvolvedifequipmentuseormodificationsdonotcomplywiththeabove
mentionedrequirements.
CAUTION
The equipment installed on the vehicle may only be used:
a) onconsistentgroundandwithvehiclelevelwithmaximumtiltof2°.
b) bycompetentandqualifiedpersonnelwhomusthavereadthismanual.Inthecaseofroadusereferto
theUseandMaintenanceManualofthevehiclemakingsurethattheoperatorisinpossessionofavalid
driver'slicenseinaccordancewiththelawsinforceinthecountryofuse(licenseBorhigherforITALY),
andthatthevehicleboomisinthefullyretractedposition.
– Some equipment be accompanied by instructions related to safety standards, connection and
disconnection,operationandmaintenance.Carefullyreadandfullyimplementtheseinstructionspriorto
installation,useandmaintenanceoftheequipment.Incaseofdoubt,contactyourlocaldealer.
– Beforestartingtousethevehicleandrelatedequipment,orbeforeperformingparticularlycomplexor
dangerousoperations,itisabsolutelynecessarytopracticeinaclearworkareafreefromobstructions.
– In case of poor visibility of the zone use a person on the ground to coordinate the movements and
operationsandthatmonitorstheareainvitingpeoplewhomightcome,togoaway.Theindividualonthe
groundmuststandatasafedistancefromthevehicleinmotionandalert,beforeanymovement,any
personalaround.
– Topreventdamaginghydraulicconnectionswhenchanginganequipment,stoptheengineandwaita
fewsecondstoremovepressurefromthecircuit.Alwayscleanconnectorsbeforetheirreinsertion.
– Check the cleanliness, protection and the conditions of quick release connections in the equipment
circuitsandontheboomheaddaily.
DANGER
Never carry the equipment in the vicinity of an open flame.
DANGER
When using the vehicle, carefully follow the respective Capacity diagrams.
It is strictly prohibited to work without the respective capacity diagrams for the type of vehicle and
installed equipment.