110
Chapter 5 1 Guaranteeing Maintenance Cycle 2 Cleaning and Oiling
S2-Y1540
(1) Cleaning
1. Slitter section and cutter section
Clean with a brush or a dry cloth.
(2) Oiling
1. Bearings
Apply a small amount of oil to the end face and axel while turning the levers and rollers.
2. Gears and Rails
Apply grease after cleaning the paper dust off of the gears.
2 Cleaning and Oiling
1 Guaranteeing Maintenance Cycle
After the delivered item, visit customer periodically and guide the DC-616 operation.
-0
To Next Page
Loading...
