Duplo DC-616 Service Manual

6
117
Chapter 6 1 Troubleshooting
S2-Y1540
-0
step
cause/failed
area
check item if action
see
page
1
Inside the
machine
• Paper jam in the machine
(feed tray unit).
• Error in the paper feed
mechanism.
YES
• Remove the paper inside
the machine.
• Check that the paper
feeds properly
-
NO Go to step 2. -
2
PPS2
Check that the PPS2 sensor
works properly in HELP
Mode: 11.
YES Go to step 3. -
NO
• Clean the sensor.
• Replace the sensor.
69
3
Connector,
Main PCB unit
Check that the PPS2 is
connected to #4 connector
of the main PCB properly.
YES Reconnect properly. -
NO Replace the main PCB Unit. 97
(3) When “J3 FEED ERROR” is Displayed
(4) When “J4 Slitter” is displayed
step
cause/failed
area
check item if action
see
page
1 JOB setting
Does not PPS3 detect
gutter slit (blank-area)?
YES
Reset slit position or pull
out gutter guides.
-
2
Inside the
machine
Paper jam inside the
machine (slitter unit).
YES
Remove the paper inside
the machine.
-
NO Go to step 3. -
3 PPS3
Check that the PPS3 sensor
works properly in HELP
Mode: 11.
YES Go to step 4. -
NO
• Clean the sensor.
• Replace the sensor.
81
4
Connector,
Main PCB unit
Check that the PPS3 is
connected to #4 connector
of the main PCB properly.
YES
Reconnect properly. -
NO Replace the main PCB Unit. 97
step
cause/failed
area
check item if action
see
page
1
Inside the
machine
Paper jam in the machine
(cutter unit or creaser unit).
YES
Remove the paper inside
the machine.
-
NO Go to step 2. -
2 PPS4
Check that the PPS4
sensor works properly in
HELP Mode: 11.
YES Go to step 3. -
NO
• Clean the sensor.
• Replace the sensor.
89
3
Connector,
Main PCB unit
Check that the PPS4 is
connected to #4 connector
of the main PCB properly.
YES Reconnect properly. -
NO Replace the main PCB Unit. 97
(5) When “J5 Cut.crease” is displayed
(HELP Mode : 11→P.137)
(HELP Mode : 11→P.137)
(HELP Mode : 11→P.137)

Duplo DC-616 Specifications

General

Brand	Duplo
Model	DC-616
Category	Paper Cutters
Language	English