Duplo DC-616 - Barcode; Description

43
Chapter 2 11 Barcode
2
S2-Y1540
1. Description
By adding barcode which indicates job number on
each document, DC-616 automatically set up the
machine and start the job. Operator can press the
START key and leave. Even if multiple types of jobs
are loaded on the feed tray at one time, DC-616
recognizes barcode on documents also with the built-
in CCD reading and automatically switch setup and
fi nish the jobs.
To use this function, each documents must have
BARCODE printed on them. Please refer to following
instructions for specifi cations and position of
BARCODE.
Paper feed direction
1. Specifi cations
Barcode type : CODE-39
Start and Stop code : Required
Minimum resolving power : 0.254 mm
Thin bar: Thick bar : 1: 2.5
Bar height : 4 mm or more
Use barcode generator function equipped on your
software application or use barcode generator
software.
11 Barcode
Barcode may not be read even it is within the
specifi cations depending on the print quality of printer
and document type. If this is the case, enlarging the
barcode may enable it to be read.
REFERENCE
-0