4
S2-Y1540
CAUTION
WARNING
2. Cautions for installation work
● The machine’s power supply voltage and power consumption are given in the table
below. The machine's power supply voltage is indicated on the identifi cation plate on
machine; the machine must be connected to a power supply of the voltage indicated.
→ Otherwise, fi re or electric shock could result.
If the power supply voltage is unstable or if the power supply has insuffi cient capacity, the
machine may not operate normally. Make sure that the power supply has suffi cient capacity
for the system as whole, including optional equipment.
Power supply
115 VAC ±10%, 60Hz 230 VAC ±10%, 50/60 Hz
Power consumption
1.5 A,190 W 0.7 A,190 W
Standby energy
0.25 A, 26 W 0.22 A,26 W
● Use only the power cord that is provided with the accessories. Insert the power cord
plug fi rmly into the socket, so that proper electrical contact is made. Use of any other
power cord could result in imperfect grounding. If grounding is imperfect and
electrical leakage occurs, fi re or electric shock could result.
●
Install the machine close to its power supply. The outlet used should be exclusively for
the machine, and have no other equipment connected to it.
If an extension cord is necessary, it should have a ground terminal, and be of the following
ratings;
• For a 120 VAC model: 130 V, at least 15 A, length not exceeding 5 m
• For a 230 VAC model: 250 V, at least 8 A, length not exceeding 5 m
● Never tread on the power cord or pinch it between other objects, or accidents could
result.
● Install the machine in accordance with the Installation Manual supplied.
● Lock the casters after the machine is installed.
→ Otherwise, the machine could move or fall over, causing injury.
-0
To Next Page
Loading...
Need help?
General
