Corner knives
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 107
5. Adjust the corner knife holder (2).
6. Tighten the screw (1).
7. Adjust the other three knife holders according to the seam pattern.
6.6 Replacing corner knives
Information
Blunt knives need to be replaced with a set of knives included in the
accessory pack.
Replacement corner knives can be ordered under the part numbers given
in the parts list.
Fig. 91: Replacing corner knives (shown on straight pocket)
To replace the corner knives:
1. Swivel out the corner knife station.
2. Remove the piercer (1) (for straight pocket only).
WARNING
Risk of injury from sharp parts!
Cutting possible.
NEVER reach into the area of the corner knives.
Replace the corner knives only with the sewing unit
switched off.
(1) - Piercer
(2) - Corner knife
(3) - Corner knife holder
(4) - Screw
(5) - Screws of the piercer
To Next Page
Loading...
