Stacker
156 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
2. Screw in or loosen the piston rod of the cylinder (1).
3. Tighten the counternut (2).
14.1.2 Setting the height of the stacker tongs
Fig. 135: Setting the height of the stacker tongs
Proper setting
The closed stacker tongs (3) should be level with the plate (4) in the tabletop.
To set the height of the stacker tongs:
1. Loosen the clamping lever (1).
2. Manually push the stacker tongs (3) forward until the tongs close.
3. Tighten the clamping lever (1).
4. Loosen the clamping lever (1) so that you can slide the stacker tongs
in both directions on the axle (2) as well.
(1) - Clamping lever
(2) - Axle
(3) - Stacker tongs
(4) - Plate
To Next Page
Loading...
