DURKOPP ADLER 745-35-10 S - Assembling the Drive Motor

Machine head
60 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
3.10.2 Assembling the drive motor
Fig. 47: Assembling the drive motor
To assemble the drive motor:
1. Slide the drive motor (3) with its shaft into the eccentric (1) towards the
front.
2. Align the motor parallel to the upper shaft and centrally to the middle
knife guide.
3. Tighten the motor with the motor fastening screws (2).
4. Tighten the screws on the eccentric (1).
5. Carefully fit the cover.
6. Tighten the screw (5) of the cover.
7. Establish the electrical connection on the motor by connecting the plug
between cable harness and motor cable.
WARNING
Risk of injury from moving parts!
Crushing possible.
Only assemble the drive motor when the sewing
unit is switched off.
(1) - Eccentric
(2) - Motor fastening screws
(3) - Drive motor
(4) - Cap
(5) - Screw
①② ③ ④ ②
⑤