Machine head
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 19
3. Swivel down the machine head carefully.
4. Insert the fabric sliding plate (4).
5. Swivel the locking lever (3) down.
6. Swivel down the folding station and latch it using the locking lever (3).
7. Replace and re-engage the hood (1).
3.5 Disassembling the machine head
It is possible to remove the machine head prior to repairs or for a quick and
easy switch to a different needle distance. This requires that the transport
carriage be in its rear position.
Fig. 6: Disassembling the machine head (1)
To remove the machine head:
1. Lift the hood (1) up at the front and the rear to release the lock.
2. Carefully life the hood (1) up and off.
3. Pull the handle of the folding station (2) up.
4. Swivel the folding station out by 90°.
WARNING
Risk of injury!
Crushing possible.
Do not remove and assemble the machine head
unless the main switch is switched off.
(1) - Hood (2) - Handle
To Next Page
Loading...
