DURKOPP ADLER 745-35-10 S - Disassembling the Switching Cylinder

Machine head
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 61
3.10.3 Disassembling the switching cylinder
Fig. 48: Disassembling the switching cylinder
To remove the switching cylinder:
1. Pull off the pneumatic hose (2).
2. Loosen the connection (3) from the cylinder if necessary.
3. Remove the drive motor ( p. 59).
4. Loosen the clamping screw (5) between switching cylinder and drive rod.
5. Pull the switching cylinder up and out.
WARNING
Risk of injury from moving parts!
Crushing possible.
Only disassemble the switching cylinder when the
sewing unit is switched off.
(1) - Motor fastening screws
(2) - Pneumatic hose
(3) - Pneumatic connection
(4) - Eccentric
(5) - Clamping screw
①
②
③④ ⑤