DURKOPP ADLER 745-35-10 S - Swiveling the Stacker to the Side

Stacker
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 159
To set the position of the tray:
1. Loosen the clamping lever (2) and adjust the position.
2. Tighten the clamping lever (2).
3. You can set the storage surface by swiveling the storage table (4) (short
and long workpieces).
4. Once you have found the right position, you can use the locking lever (3)
to peg the storage table (4) in place using the corresponding hole.
14.1.6 Swiveling the stacker to the side
Fig. 139: Swiveling the stacker to the side
To perform setting operations on the corner knives, you can swivel the
stacker to the side.
To swivel the stacker to the side:
1. Loosen the quick release (2).
2. Swivel the stacker to the side.
3. Swivel the stacker back to its position after completing the setting
operations.
4. Tighten the quick release (2).
5. You can use the locking plate (1) to align the stacker parallel to the
machine.
(1) - Locking plate (2) - Quick release
①
②