Setting fabric sliding plate and vacuum plate
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 133
11 Setting fabric sliding plate and vacuum plate
Fig. 115: Setting fabric sliding plate and vacuum plate
Proper setting
The vacuum plate is in the same plane as the tabletop.
To set fabric sliding plate and vacuum plate:
1. Swivel the fabric sliding plate aside.
2. Check the height of the vacuum plate in relation to the tabletop.
3. Turn the threaded pin (1).
• Set vacuum plate higher: turn clockwise
• Set vacuum plate lower: turn counterclockwise
4. Readjust the supporting screws (2).
WARNING
Risk of injury from moving parts!
Crushing possible.
Set fabric sliding plate and vacuum plate only when
the sewing unit is switched off.
(1) - Threaded pin (2) - Supporting screws
To Next Page
Loading...
