DURKOPP ADLER 745-35-10 S - Assembling the Needle Bar Linkage

Machine head
38 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
3.8.6 Assembling the needle bar linkage
Fig. 25: Assembling the needle bar linkage (1)
To assemble the needle bar linkage:
1. Slide the support plate (1) onto the needle bar linkage (2).
2. Press the bearing bolt (3) into the support plate (1) and the needle bar
linkage (2).
3. Tighten the clamping screw (8).
 The needle bar linkage (2) must be close to the support plate (1), but
retain its free movement.
4. Carefully slide the support plate (1) with the needle bar linkage (2) onto
the stop pin (4).
5. Insert and slightly tighten the fastening screw (5).
6. Move the adjusting screw (7) up to the stop pin (4) and secure it using
the counternut (6).
 The adjusting screw (7) regulates the height of the needle bar linkage.
WARNING
Risk of injury from moving parts!
Crushing possible.
Only assemble the needle bar linkage when the
sewing unit is switched off.
(1) - Support plate
(2) - Needle bar linkage
(3) - Bearing bolt
(4) - Stop pin
(5) - Fastening screw
(6) - Counternut
(7) - Adjusting screw
(8) - Clamping screw
①
②③④②
①
⑥⑦⑧
⑤