Maintenance
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 303
Check and clean daily
• Use a compressed air gun to clean the areas of hook (2) and (3).
• Clean the lenses of light barriers (1) and (4) at the remaining thread
monitor with a soft cloth every time you change the bobbin.
• Clean the filter ring (6) at the vacuum valve (5) by blowing out the filter
using a compressed air gun.
17.2 Lubricating
For topping off the oil reservoir, use only lubricating oil DA 10 or oil of
equivalent quality with the following specifications:
• Viscosity at 40 °C: 10 mm²/s
• Flash point: 150 °C
CAUTION
Risk of injury from contact with oil!
Oil can cause a rash if it comes into contact with
skin.
Avoid skin contact with oil.
If oil has come into contact with your skin, wash the
affected areas thoroughly.
NOTICE
Property damage from incorrect oil!
Incorrect oil types can result in damage to the machine.
Only use oil that complies with the data in the instructions.
CAUTION
Risk of environmental damage from oil!
Oil is a pollutant and must not enter the sewage
system or the soil.
Carefully collect up used oil.
Dispose of used oil and oily machine parts in
accordance with national regulations.
To Next Page
Loading...
