DURKOPP ADLER 745-35-10 S - Setting the Bobbin Case Holding Wire

Machine head
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 57
8. Slip a new hook onto the hook shaft.
 The position of the hook on the hook shaft is determined by the
arrangement of the holes at the bottom of the hook. This ensures that
the hook tip returns to the middle of the needle after completing the
loop stroke.
9. Insert the bobbin case bottom part (2) into the hook.
Important
The holding lug (6) of the bobbin case bottom part must engage in the slot
of the throat plate.
10. Place the hook cover (4) and assemble it with the screws (3).
11. Insert the throat plate (7).
3.9.8 Setting the bobbin case holding wire
Fig. 45: Setting the bobbin case holding wire
WARNING
Risk of injury from moving parts!
Crushing possible.
Do not check and adjust the bobbin case holding
wire unless the sewing unit is switched off.
(1) - Plate
(2) - Screw
(3) - Bobbin case holding wire
(4) - Edge 1
(5) - Edge 2
(6) - Bobbin case top part
(7) - Holding lug
(8) - Screw
(9) - Clamping screw
①
②③④⑤⑥
⑦
⑧
⑨
③①⑥
⑤