Transport clamps
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 85
5 Transport clamps
Fig. 70: Transport clamps
The unhindered transport of the sewing material and the proper execution
of the pocket opening require that the folding and cutting tools as well as
the marking lamps are aligned with the middle of the pocket opening.
The middle of the pocket opening is defined as the center between the two
needle holders.
Use the edge of the sliding plate (measuring line) (1) to set and check the
folding and cutting tools.
The sliding plate edge (1) runs parallel to the feed mechanism at a
distance of 100 mm.
(1) - Edge of the sliding plate (measuring line)
To Next Page
Loading...
