Transport carriage
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 77
4.1.2 Setting the distance between switching screw and reference
switch
Fig. 64: Setting the distance between switching screw and reference switch
Proper setting
When the transport carriage (3) is in its rear end position, the distance
between reference switch (1) and switching screw (2) must be 1 mm.
To set the distance between switching screw and reference switch:
1. Loosen the screw on the switching screw (2).
2. Adjust the height of the switching screw (2).
Set the distance between switching screw (2) and reference switch (1) to
0.5 - 1 mm.
3. Tighten the counternut.
4. Slide the transport carriage (3) all the way back.
5. Verify that the distance between reference switch (1) and screw (2) is
0.5 - 1 mm.
(1) - Reference switch
(2) - Switching screw
(3) - Transport carriage
To Next Page
Loading...
