Transport clamps
92 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
Checking the transport clamp quick adjustment
To check the transport clamp quick adjustment:
1. Uncouple both locking plates (disengage pneumatically).
2. Place a white sheet of paper on the sliding plate.
3. Press the pedal forwards and move the transport clamps to the front.
4. Lower the folder.
5. Check the distance between transport clamp and folder.
5.4 Setting the front end position of the transport clamp
Fig. 77: Setting the rear end position of the transport clamp
NOTICE
Property damage may occur!
The folder collides with the transport clamps while being lowered.
The transport clamp position must be adjusted to the appropriate
folder.
WARNING
Risk of injury from moving parts!
Crushing possible.
Set the transport clamp only with utmost caution
and with the sewing unit switched on.
(1) - Reference switch (2) - Rear stop
To Next Page
Loading...
