Transport clamps
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 93
Proper setting
Dimensional check for the front edge of the transport clamp:
• Spacing A (front positioning point) + sewing length + 15 mm
The front edge of the transport clamp must, therefore, be at a distance
of 111+180+15 = 306 mm from the middle of the needle.
To set the front end position of the transport clamp:
1. Move up to the reference switch (1).
The transport clamp moves to the rear position, as viewed by the user.
A press of the pedal moves the transport carriage to the front.
2. Difference between the reached position and the calculated target
position.
3. Switch off the main switch.
4. Correct the reference switch (1) by the difference ( p. 76).
5. Correct the rear stop (2) ( p. 78).
6. Switch on the main switch.
7. Make another reference run and check the dimension for the front edge
of the transport clamp.
To Next Page
Loading...
