Stacker
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 163
14.2.2 Setting the throw-over stacker
Fig. 143: Setting the throw-over stacker (1)
Information
The switch actuation point is advanced or delayed by turning the switch
cams towards (-) = earlier or (+)=later.
Fig. 144: Setting the throw-over stacker (2)
To set the throw-over stacker:
1. Start signal: Swivel bracket (2) closes.
2. The switch (5) is pressed approx. 5 mm before the stacking bracket (1)
is reached.
3. Loosen the screw (6) and adjust the switch cam (7) by turning.
(1) - Stacking bracket
(2) - Swivel bracket
(3) - Throw-over bracket
(4) - Clamping bracket
(5) - Switch
(6) - Screw
(7) - Switch cam
To Next Page
Loading...
