DURKOPP ADLER 745-35-10 S - Setting the Transport Carriage Stop

Transport carriage
78 Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
4.1.3 Setting the transport carriage stop
Fig. 65: Setting the transport carriage stop
Proper setting
The stop (4) is at a distance of 2 mm from the transport carriage (3).
To set the stop for the transport carriage:
1. Slide the transport carriage (3) back until the surface of the switching
screw (2) is positioned at the center below the reference switch (1).
2. Loosen the counternut on the stop (4).
3. Move the stop (4) up to the transport carriage until it is at a distance
of 2 mm
4. Tighten the counternut on the stop (4).
(1) - Reference switch
(2) - Switching screw
(3) - Transport carriage
(4) - Stop
①
②
④
③