DURKOPP ADLER 745-35-10 S - Setting the Folder Detection

Folder
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 145
12.6 Setting the folder detection
Fig. 127: Ensuring folder detection
Proper setting
Switches S11 (2) and S12 (3) are used to check if the folder used belongs
to the selected seam program.
Switch S11 (2) must be pressed for single piping on the right.
Switch S12 (3) must be pressed for single piping on the left.
The distance between the switches and the switching flag should be ap-
prox. 1 mm.
To set the folder detection:
1. Slightly loosen the nuts (1).
2. Set the distance between the switching flag and switches S11 (2) and
S12 (3).
3. Re-tighten the nuts (1).
WARNING
Risk of injury from moving parts!
Crushing possible.
Do not check and adjust the switching flag unless
the sewing unit is switched off.
(1) - Nuts
(2) - Switch S11
(3) - Switch S12
①
③
②