Additional equipment
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 151
2. Loosen the threaded pin (1).
3. Shift the actuating lever in such a way that both transport rollers (5)
and (7) exert a slight pressure on the tabletop.
4. Tighten the threaded pin (1).
5. Tighten the hexagon screws (6).
Setting the throttle valves
To set the throttle valves:
1. Set the lifting speed at the throttle valve (3).
2. Set the lowering speed at the throttle valve (4).
The lowering speed should allow for a rapid, but not abrupt movement.
Setting roller speed and duty cycle
The rolling speed and the duty cycle of the transport rollers are set at the
OP7000 control panel ( p. 253).
To Next Page
Loading...
