Programming
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 197
Selecting a pocket program
Information
By default, the seam program currently selected will be active on the start
screen.
You can use the option Select pocket program to quickly configure
several pocket programs in a row.
To select a pocket program:
1. Use the numeric keypad to set the desired pocket program (1-99).
2. Confirm with OK.
The display switches to the selected pocket program.
You can configure the selected pocket program as described below.
Important
When you return to the start screen after configuring the selected pocket
program, the previous pocket program will be active again. To activate the
pocket program you configured, you must add it to the seam sequence
( p. 181).
If the pocket program has already been copied to the selected seam
sequence, you can activate it in the seam sequence ( p. 193).
To Next Page
Loading...
