DURKOPP ADLER 745-35-10 S - Page 215

Programming
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017 213
Middle knife parameters
 The display switches to Middle knife parameters.
Fig. 185: Middle knife parameters
To set the middle knife parameters:
1. Press the desired button.
2. Enter the desired value using the numeric keypad.
3. Confirm with OK.
Symbols Meaning
Middle knife On/Off
Set middle knife correction seam begin.
• -9.9 mm - 9.9 mm
Set middle knife correction seam end
• -9.9 mm - 9.9 mm
Set speed middle knife
• 100 RPM - 3000 RPM