Descripon
Typical display
Dry pump speed in Hz DP SPEED 100 Hz
Booster speed in percent MB SPEED 100 %
Booster speed in Hz MB SPEED 100 Hz
Dry pump inverter temperature DP INV TEMP 100 C
Booster inverter temperature MB INV TEMP 100 C
Exhaust pressure EXHAUST 5 PSI
Exhaust temperature EXH PIPE TEMP 100 C
Water ow rate WATER 11.1 l/m
Run hours RUN HOURS 1000
Number of pump starts PUMP STARTS 100
Time to stop (seconds) TIME TO STOP 900
Acve alarms and warnings
Solvent soak SOLVENTSOAK O
Dry pump clean DP CLEAN O
Acve strain gauge ASG 3.4E+01 mbar
PT100 temperature PT100 1 108 C
Pressure transducer PR 105.0 kPa
PID auto tune status PID TUNE Normal
9.4.3 Setup menu
Press the SETUP buon to enter. The menu tle is shown at the top of the display. Scroll
by pressing the UP/DOWN keys. Press ENTER to open a sub menu or CANCEL to exit back
to Normal menu.
Table 31
PDT setup menu structure
Descripon
Display
Commands menu* Command Menu...
Set sequences menu* Set Sequences...
Display inverter fault history menu Inv Fault Hist...
Soware version display menu S/W Version...
Display serial number Serial Num...
Fit accessory menu* Fit Accessory...
Edit IP conguraon menu IP Cong...
Edit display aributes menu Display Ar...
Set me and date Set Clock...
Display pump type Show pump type...
* This opon requires a security code to access it.
Each sub menu is described below.
Page 123
M58800880_H - Pump display terminal