Edwards GXS Series

9.15.2 Run the booster using SIM and Probus
Refer to the SIM and Probus manuals for informaon on how to control the booster
using these protocols.
9.15.3 Run the booster using the MCM MicroTIM
If controlling the booster independently using the MCM MicroTIM then Input 2 needs to
be congured to Booster. Refer to How to set up the MCM MicroTIM using the PDT on
page 156 for the instrucons on how to congure the MCM MicroTIM using the PDT.
Once the Input 2 has been congured to Booster, Input 2 will start and stop the booster
independently of the dry pump.
Page 159
M58800880_H - Pump display terminal