Parameter
Boom Page 2...
In each opon, the select parameter menu is opened, scroll through the parameters by
pressing the UP/DOWN keys. Press ENTER to select the parameter for display or CANCEL
to exit back to the Select line menu.
9.4.25 Set clock
Under the Setup menu. Press ENTER to change the date and me displayed or press
CANCEL to exit back to the Setup menu.
For each digit seng press the UP/DOWN keys to set the digit, press ENTER to accept
and move to the next digit or CANCEL to move back to the previous digit. Pressing
ENTER at the end of the line will accept the new seng and exit back to the Set Clock
menu. Pressing CANCEL at the start of the line will cancel and exit back to the Setup
menu.
9.5 How to set up the PDT display
The conguraon opons for the PDT are stored in the PDT itself and are not associated
with the pump that the PDT is connected to. This means the user can transfer a PDT
between pumps and keep the same sengs. It also means that dierent units could be
displayed on two PDTs connected to the same pump.
The following PDT menus are used to congure the PDT display.
Page 133
M58800880_H - Pump display terminal
To Next Page
Loading...
Need help?
General
