Edwards GXS Series User Manual

Figure 61 Smart Stop PDT menu conguraon items
▪
Smart Stop is enabled and disabled using the enable/disable menu item.
▪
The maximum me that the pump will run while shung down is set using the
Stop me menu item.
▪ The size of the dry pump speed reducons is congured using the Step size menu
item. The me between speed step reducons is automacally calculated by the
soware based on the size of the speed step reducons and the maximum me
the pump will run.
▪ The pump can be triggered to stop when its internal temperature reaches a certain
set point. Select the Setpoint menu to congure the set point temperature.
▪ The pump can be triggered to stop a certain me period aer it has cooled to the
set point temperature. Select the Sele me menu to adjust the me period.
9.8.2 How to congure ramped speed increase
The pump has a congurable intelligent on‑process behaviour mode called on‑process
ramp. When the on‑process ramp is enabled, the speed of the pump is ramped up
gradually when accelerang from the green mode/standby speed to the process speed.
This gradual acceleraon can prevent a large disturbance to the process load which
could result in a slug of process material being drawn into the pump.
Note:
The on ‑ process ramp is only eecve if the Green mode/standby speed of less than full
speed has been set. Contact us for more informaon about conguring the Green mode/
standby speed.
The following menus are used by the PDT to on‑process ramp:
Page 140
M58800880_H - Pump display terminal

Edwards GXS Series Specifications

General

Brand	Edwards
Model	GXS Series
Category	Water Pump
Language	English