Section 2 — System Control EPS-16 PLUS Musician's Manual
This page allows the sustain foot switch to act as a sustain pedal or a patch select
button.
• When set to SUSTAIN FT SW=SUSTAIN the single SW-1 foot switch which
comes with the unit, or the right-hand pedal on the optional SW-5 Dual Foot
Switch acts as a sustain pedal.
• When set to SUSTAIN FT SW=PATCH SL the foot switch will reproduce the
actions of the right-hand patch select button, and will cease to act as a sustain
pedal.
This page allows the auxiliary Foot Switch (available only with the optional SW-5
Dual Foot Switch) to either start and stop the sequencer or to act as the left-hand
patch select button. See Section 1 — Getting Started for more details.
• OFF — This setting makes the EPS-16 PLUS ignore the left footswitch. If you
arc arc using the single footswitch (SW-1) which came with the EPS-16
PLUS, then you should keep this parameter set to OPT.
• When set to AUX FT SW=START/STOP, the left pedal of the SW-5 duplicates
the action of the Stop•Continue button.
• When set to AUX FT SW=PATCH SEL, the left pedal duplicates the behavior
of the left-hand patch select button and will cease to act as a sequencer start/stop
pedal.
This parameter enables or disables the "Expert-System" auto-loop function. If the
auto-loop function is enabled, the EPS-16 PLUS will automatically go to zero
crossings (with matching wave direction) whenever you move the loop start or
end pointer. This is a very useful feature because finding zero crossings is
essential to creating glitch-free loops. If the auto-loop function is disabled, the
loop start and end parameters will move in one-sample increments.
2 - 4 EDIT Systenr•MIDI Page
To Next Page
Loading...
Need help?
General
