EasyManuals Logo

ENSONIQ EPS-16 PLUS Musician's Manual

ENSONIQ EPS-16 PLUS
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
EPS-16 PLUS Musician's Manual Section 2 System Control
This parameter determines whether voices assigned to Bus 2 and Bus 3 on the
EDIT/Amp or EDIT/Track page will be sent through the internal effects
processor, ultimately coming out of the Left/Right Audio Outs, or will be sent
exclusively to the auxiliary outputs of the EPS-16 PLUS.
Setting these parameters to OFF provides the signal separation that will most
likely be desired when using the additional outputs. If these parameters are left
ON when using the additional outputs, the Dry portion of the signal sent to Bus
2 and Bus 3 would come out of the auxiliary outputs, while the signal with
Effects would come out of the EPS-16 PLUS' Left/Right Audio Outs.
These parameters should be set to ON when not using any auxiliary outputs,
allowing you to use up to three effects busses.
As you can see from the diagram, the signal is sent to the auxiliary outputs
before entering the signal processor. Therefore, the signals coming out of the
auxiliary outputs are always dry (no effects).
EDIT System•MIDI Page 2 - 5

Table of Contents

Other manuals for ENSONIQ EPS-16 PLUS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ENSONIQ EPS-16 PLUS and is the answer not in the manual?

ENSONIQ EPS-16 PLUS Specifications

General IconGeneral
BrandENSONIQ
ModelEPS-16 PLUS
CategoryRecording Equipment
LanguageEnglish

Related product manuals