21 Outputs FLUXUS G60x
UMFLUXUS_G6V4-2EN, 2011-03-29 161
Alarm outputs with the switching condition ERROR will only be activated after several un-
successful measuring attempts. Therefore, typical short-term disturbances of the mea-
surement (e.g. switching on of a pump) will not activate the alarm.
Alarm outputs with the switching condition +→- -→+ and of the type NON-HOLD will be acti-
vated with each change of the flow direction for approx. 1 s (see Fig. 21.2).
Alarm outputs with the switching condition
+→- -→+ and of the type HOLD will be active af-
ter the first change of the flow direction. They can be switched back by pressing key C
three times (see Fig. 21.2).
Fig. 21.2: Behavior of a relay when the flow direction changes
If there is an internal adaptation to changing measuring conditions, e.g. to a considerable
rise of the medium temperature, the alarm will not switch. Alarm outputs with the switch-
ing condition OFF will be set automatically to the switching function NO Cont..
21.7.5 Alarm State Indication
The alarm state can be displayed during the measurement. This function is activated in
Special Funct.\SYSTEM settings\Dialogs/Menus.
Scroll during the measurement with key until the alarm state is displayed in the upper
line.
RX =
, with
being a pictogram as shown in Tab. 21.6.
Note! There is no visual or acoustic indication of alarm output switching.
Select the menu item SHOW RELAIS STAT. Select on to
activate the alarm state indication.
example: R1 =
D u r c h f l u s s
+
-
0
A l a r m t y p : H A L T E N D
C
M a n u e l l e s R ü c k s e t z e n
d e s A l a r m s
D u r c h f l u s s
+
-
0
A l a r m t y p : N I C H T H A L T E N D
c a . 1 s
flow
type NON-HOLD
type HOLD
reset of the alarm
(3x key C)
approx. 1 s
flow
SHOW RELAIS STAT
off >ON<
To Next Page
Loading...
