Chapter 3: Certify Twisted Pair Cabling
DSX CableAnalyzer Connectors, Keys, and LEDs
73
PASS LED comes on when a test passes.
TEST LED flashes during a test.
FAIL LED comes on when a test fails.
TALK LED comes on when the talk function is on (
). The LED
flashes until the main tester accepts the request to talk. See
“How to Use the Talk Function” on page 157.
TONE LED flashes and the tone generator comes on if you press
when a main tester is not connected to the remote. See
“How to Use the Tone Generator” on page 155.
LOW BATTERY LED comes on when the battery is low. The LEDs
also have these functions:
Battery gauge (see Figure 3 on page 20)
Volume indicator for the TALK function
Progress indicator for software updates
: Starts a test. Turns on the tone generator if a main tester is
not connected to the remote. See “How to Use the Tone
Generator” on page 155.
: Power button. The LED in the power button shows the
status of the battery charging process. See Table 2 on page 18.
: Press to use the headset to speak to the person at
the other end of the link. See “How to Use the Talk Function” on
page 157.
Connector for the AC adapter. Versiv: The LED is red when the
battery charges, and green when the battery is fully charged.
The LED is yellow if the battery will not charge. See “Charge the
Battery” on page 18.
Micro USB port: This USB port lets you connect the tester to a PC
so you can upload test results to the PC.
Headset jack. See “How to Use the Talk Function” on page 157.
To Next Page
Loading...
