Fluke DSX-8000 - To Use a Different, Unused ID from an ID Set that Has a First and Last ID; To Use an ID You Used before; To Use an ID that Is Not in an ID Set that Has a First and Last ID

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
542
To use a different, unused ID from an ID set that has a first and last
ID
If Auto Save is on or off:
1 On the home screen, tap the Next ID panel.
2 On the CHANGE ID screen, tap an ID in the list under IDs
Untested, then tap DONE.
3 Do the test. After you save the results, the tester uses the next
ID in the set for the next results.
If Auto Save is off:
1 Do the test, then tap SAVE if the test passed or FIX LATER if
the test failed.
2 Enter the ID on the SAVE RESULT screen, then tap SAVE. After
you save the results, the tester uses the next ID in the set for
the next results.
To use an ID you used before
 If the test failed before, turn on Auto Save, select the saved
result on the RESULTS screen, then tap TEST AGAIN or press
. See “How to Make ID Sets” on page 548.
 If the test passed before, do the test again, then enter the ID
on the SAVE RESULT screen.
To use an ID that is not in an ID set that has a first and last ID
If Auto Save is on or off:
1 On the home screen, tap the Next ID panel.
2 On the CHANGE ID screen, tap the panel that shows the Next
ID.
3 Use the keyboard to enter an ID, then tap DONE on the
keyboard.