Fluke DSX-8000 - How to Use the Talk Function

Chapter 3: Certify Twisted Pair Cabling
How to Use the Talk Function
157
How to Use the Talk Function
If you have two testers and two DSX CableAnalyzer modules, you
can use the talk function to talk to the person at the other end of
a twisted pair link.
Note
The talk mode does not operate during tests.
To use the talk function
1 Connect the main and remote testers together through a link
that has one or more good wire pairs.
2 Connect headsets to the headset jacks on the testers (see
Figure 21 on page 70).
3 Press the button on one of the headset microphones or press
 on the remote tester, then speak into the microphone.
When the talk function is on, shows at the top of the screen
on the main tester. On the remote tester, the TALK LED is on.
4 To adjust the volume at the main tester, press the button on
the headset’s microphone as necessary, or move the slider
control in the Talk Enabled window.
To adjust the volume at the remote tester, press  or the
button on the headset’s microphone as necessary. The LEDs on
the remote show the volume level.
5 To turn off the talk function, hold down the button on one of
the headsets or hold down  on the remote tester.