Fluke DSX-8000 - How to Do the Fiberinspector Test

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
222
How to Do the FiberInspector Test
Figure 96 shows the equipment for a FiberInspector test.
Figure 96. Equipment for the FiberInspector Test
Note
You can do the FiberInspector test with no
module installed, but you should keep a module
installed to give protection to the connector on
the tester.
To do the FiberInspector test
Refer to Figures 97 and 98.
1 Connect the FI-1000 probe to the type A USB port on the side
of the tester.
2 Install the correct tip on the probe.
3 Clean the connector that you will inspect.
GPU174.EPS
 Main tester with CertiFiber Pro,
OptiFiber Pro, or blank module
installed
 FI-1000 video probe with USB
connector
 Fiber cleaning supplies
 AC adapter with line cord
(optional)
A
D
C
B