Fluke DSX-8000 - Certifiber Pro OLTS Loss;Length Specifications

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
620
CertiFiber Pro OLTS Loss/Length Specifications
Specification
CertiFiber Pro
Multimode Modules
CertiFiber Pro
Singlemode Modules
Testing speeds
(excluding
referencing times)
Smart Remote mode (2 wavelengths, one direction):  3s
Far End Source mode
1
(2 wavelengths, one direction): 2s
Loopback mode (2 wavelengths, one direction):  2s
Input/output
connectors
Interchangeable connector adapter (LC standard on input,
SC standard on output)
Launch Condition
Encircled flux compliant to TIA 455-526-14-B,
ISO/IEC 14763-3, and IEC 61280-4-1
2,3
Fiber types tested
50/125 μm, 62.5/125 μm
multimode fiber
Singlemode fiber
Source type and
wavelengths
Multimode LED source
850 nm  30 nm
1300 nm  20 nm
Fabry-Perot laser diode
1310 nm  20 nm
1550 nm  30 nm
Maximum length
measurement
12 km 130 km
Length
measurement
accuracy
 1.5 m plus  1 % of length
Output power
(nominal)
 -24 dBm with EF-TRC  -4 dBm
Output power
stability
4
 0.05 dB over 8 hours
 0.03 dB over 15 minutes
 0.1 dB over 8 hours
 0.08 dB over 15 minutes
1. In Auto CertiFiber Pro mode. In Auto SimpliFiber Pro mode: < 4 seconds (2
wavelengths). With the source in continuous-wave mode: < 1 second (1 wavelength).
2. At the output of the EF-TRC.
3. Variations between EF measurement equipment may occur but EF compliance can be
expected with a 95 % confidence factor.
4. At constant temperature, relative to power level after 15 minute warm up.