Fluke DSX-8000 - Import an ID Set into a Project; Delete an Imported ID Set

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
552
Import an ID Set into a Project
You can use LinkWare PC software to make ID sets, download
them to the tester, then import them into projects.
Note
ID sets that you download to the tester must have
the extension “.ids”.
To import an ID set
1 In LinkWare PC, select Utilities > (module name) > Create ID
List to make an ID set and download it to the tester.
2 On the home screen, tap the PROJECT panel.
3 Make sure the correct project shows on the PROJECT screen. If
necessary, tap CHANGE PROJECT to select a different project.
4 On the PROJECT screen tap NEW ID SET, then tap IMPORT.
5 On the IMPORT CABLE ID screen, tap the ID set you
downloaded.
6 Under Select Media, tap Copper or Fiber to specify the type of
tests that will use the IDs.
For IDs for fiber tests: Under Fiber, select the tests that are
necessary for the project. These selections let you use the %
Tested value on the home screen to monitor the progress of the
project.
7 Tap IMPORT.
Delete an Imported ID Set
If you go to the PROJECT screen and delete a cable ID set that you
imported into the project, the ID set is still available in the tester.