Chapter 17: Use Projects
Tutorial: How to Use a Project for Tests with a CableAnalyzer Module
533
Step 2: Select a Test for Twisted Pair Cable
On the home screen, tap the test type panel, on the CHANGE
TEST screen (Figure 201), tap the test you made for twisted pair
cable, then tap USE SELECTED.
If the active ID set was not made for copper media, the tester
shows a warning. When you tap OK, the tester shows the
CHANGE CABLE IDs screen. Select the copper ID set that starts
with B-00, which you made in the previous tutorial.
GPU54.EPS
Figure 201. CHANGE TEST Screen
To select a test, tap the test.
To add a test to the project, tap NEW TEST.
To Next Page
Loading...
