Versiv Series Cabling Certification Product Family
Technical Reference Handbook
18
Charge the Battery
Before you use the battery for the first time, charge the battery
for about 2 hours with the tester turned off.
To charge the battery
Connect the AC adapter to the 15V jack on the left side of the
tester.
Versiv 2: The LED in the power button shows the status of the
battery charging process. See Table 2.
Versiv: The LED near the AC adapter connector is red when the
battery charges, and green when the battery is fully charged. The
LED is yellow if the battery will not charge.
A fully-charged battery operates for approximately 8 hours of
typical use. The battery takes approximately 4 hours to fully
charge when the tester is turned off.
Notes
You do not need to fully discharge the battery
before you recharge it.
The battery will not charge if its temperature is
outside the range of 32 °F to 104 °F (0 °C to 40 °C).
The LED is yellow if the battery will not charge.
Table 2. Power Button’s LED Indications for Versiv 2 Testers
Green, steady: The tester is on and the AC adapter is not
connected, or the AC adapter is connected and the battery is
fully charged.
Green, flashing: The tester is off, the AC adapter is connected,
and the battery is fully charged.
To Next Page
Loading...
